--- gvpe/doc/gvpe.conf.5.pod	2005/12/05 12:58:08	1.15
+++ gvpe/doc/gvpe.conf.5.pod	2006/11/22 22:55:15	1.17
@@ -118,11 +118,12 @@
 eight times the minimum (= expected) latency, assuming the request or
 reply has been lost.
 
-For congested links a higher value might be necessary (e.g. C<30>). If the
-link is very stable lower values (e.g. C<2>) might work nicely. Values
-near or below C<1> makes no sense whatsoever.
+For congested links a higher value might be necessary (e.g. C<30>). If
+the link is very stable lower values (e.g. C<2>) might work
+nicely. Values near or below C<1> makes no sense whatsoever.
 
-The default should be working ok for most links.
+The default should be working ok for most links but will result in low
+throughput if packet loss is high.
 
 =item if-up = relative-or-absolute-path
 
@@ -419,7 +420,7 @@
 
 3. Allow the connection.
 
-That is, C<allow-direct> takes precende over C<deny-direct>.
+That is, C<allow-direct> takes precedence over C<deny-direct>.
 
 The check is done in both directions, i.e. both nodes must allow a direct
 connection before one is attempted, so you only need to specify connect