--- gvpe/doc/gvpe.texi	2006/01/18 13:15:07	1.1
+++ gvpe/doc/gvpe.texi	2007/03/29 17:35:20	1.2
@@ -720,7 +720,7 @@
 @refill
 For congested links a higher value might be necessary (e.g. @t{30}). If the link is very stable lower values (e.g. @t{2}) might work nicely. Values near or below @t{1} makes no sense whatsoever.
 @refill
-The default should be working ok for most links.
+The default should be working ok for most links but will result in low throughput if packet loss is high.
 @refill
 
 
@@ -1096,7 +1096,7 @@
 @refill
 3. Allow the connection.
 @refill
-That is, @t{allow-direct} takes precende over @t{deny-direct}.
+That is, @t{allow-direct} takes precedence over @t{deny-direct}.
 @refill
 The check is done in both directions, i.e. both nodes must allow a direct connection before one is attempted, so you only need to specify connect limitations on one node.
 @refill